Belkin Extender – WPS & Belkin.range Setup

 

There is never a single method of setting up or installing a wifi range extender. Similarly, for the Belkin wifi range extender, there are two distinct methods. You can choose the method of setting up according to your preference. The WPS setup method is very convenient to perform if your router and extender have the WPS button on them. Belkin.range setup is the manual method for setting up your extender in case your router or extender doesn’t support the WPS button. 

Belkin Extender Setup – WPS Method

The WPS button makes it simple to set up any WiFi extender. It can however only be done if the router and extender each support the WPS button. Follow these instructions to complete the Belkin wifi extender installation using the WPS button;

Step 1. Switch on your WiFi router and then you can also connect the Belkin range extender to the power outlet.

Step 2. Following that, you need to press and hold down the WPS key on the Belkin range extender for around 5 to 7 seconds.

Step 3. Release the button when you see that the LED for power is blinking on your device.

Step 4. Within the 2-minute duration, press the WPS button on the wireless router in order to activate the WPS on the range extender feature.

Step 5. Sit patiently for a few minutes and then let the devices connect.

Belkin Extender Setup – Belkin.range Method

Follow these steps for the Belkin setup using the assistance of the internet browser, in the event that the router or extender doesn’t allow using the WPS button. It is essential to follow these steps strict way to avoid errors;

Step 1: The first step is to connect the Belkin range extender to the electrical outlet. It is vital to attach to the Belkin range extender with your router.

Step 2: Go to the WiFi section of the device you want to be able to join with the extender device.

Step 3: Afterwards you need to be connected to a wireless network close to you. After that, you can click on your Belkin configuration.

[It is possible that the name you have chosen for the extender doesn’t appear in the list of wireless networks that are available on the list. If this is the case then you’ll have to reset the extended device by pressing the reset button within the Belkin extender. To reset it, you need to hold the device for 10 seconds, and then be patient until the blue LEDs flash across the device. You’ll then find the default name in the network list.]

Step 4: The next step is to launch the latest web browser you’ve installed on your computer.

Step 5: Enter the Belkin.range into the address bar of your browser to open the Belkin range extender’s administrator settings. 

[If the address you see on the web doesn’t work for you, you may try your IP address 192.168.206.1 to configure the extender.]

Step 6: You’ll be able to see a new site appear in your browser. You must click on the button to begin. After that, it will begin searching for that wifi router’s SSID.

Step 7: When the page stops being able to load, restart the website. Next, choose the wireless network you’d want to extend using the Belkin range extender. Click Next.

Step 8: Allow an extended period of time until the connection is successfully connected.

Step 9: Type in your password for your favorite wireless service. Then, click Next.

Step 10: Your selected password will be confirmed.

Step 11: Once you have completed that, you’ll see an announcement on the display that states the Belkin Wireless setup has been completed and you’ll be able to extend the area of coverage for the wireless network.

Belkin Signals Extended!

Above-mentioned both the methods of setup are easy to follow, however, Belkin.range setup method is convenient with all kinds of devices and versions. So, start your extender setup now and enjoy the extended network all over your place without any obstacles.